User Manual Q&AAnswer
Dec 09, 2025 - 12:12 PM
To switch between Manual and Auto mode on the STARMATRIX Clever-Pool Pump Inverter and set up the different modes, follow these steps as outlined in the product manual:
1. **Manual Mode:**
- Press the SET/RESET button once in stop mode to switch to Auto Mode.
- In stop mode, the display will show MANUAL, LOW RPM, and the speed in rpm.
- Use the up or down buttons to select the speed or press one of the preset speed buttons (LOW RPM, MEDI RPM, HIGH RPM).
- Press the RUN/STOP button to start the pump at the selected speed. The Clever-Pool will store this speed for future use.
- To stop the pump, press the RUN/STOP button again.
2. **Auto Mode:**
- Press the SET/RESET button once in stop mode to switch to Auto Mode.
- In Auto Mode, you can set up to 4 separate timers with individual speed options.
- Press the SET/RESET button to step over from hours to minutes and set the current time.
- Press the SET/RESET button to step to SPEED setting. Adjust the motor speed using the up or down buttons or preset speed buttons.
- Repeat the above steps to set speed, start, and stop times for each of the 4 Auto Modes.
- After setting all timers, the Clever-Pool will start and stop the pump at the specified times and speeds.
3. **Back Wash Mode:**
- In stop mode, press the SET/RESET button once.
- Press the BACKWASH button to activate backwash mode.
- Press the RUN/STOP button to start the pump in backwash mode.
- Press the RUN/STOP button again to stop the pump.
Remember to always follow the safety and caution guidelines provided in the instruction manual when operating the Clever-Pool Pump Inverter. If you encounter any issues or have further questions, refer to the troubleshooting section in the manual for error code explanations and solutions.
Add New Comment