User Manual Q&AAnswer
Dec 09, 2025 - 10:36 AM
To initialize the network camera, follow these steps:
1. Cut the power supply to the camera by unplugging the AC power cord or turning off the power supply of the tested PoE injector.
2. Turn on the power of the camera while holding down the INITIAL SW and keep it held down for 10-15 seconds.
3. In about 2 minutes after releasing the INITIAL SW, the camera will start up, and the settings, including the network settings, will be initialized.
It is important to note that if the INITIAL SW is not held down for 10-15 seconds, the camera may fail to initialize and cause malfunction. Also, ensure not to turn off the power of the camera during the initialization process to prevent any issues.
Add New Comment