User Manual Q&AAnswer
Dec 09, 2025 - 09:30 AM
To access the Hanwha Vision SPA-D1000 IP Audio Module for the first time and set it up on your network, follow these steps as outlined in the user manual:
1. **Accessing the Audio Module:**
- Connect your PC to the same network as the product using a network cable.
- Set your PC's IP address to 192.168.1.x (e.g., 192.168.1.100).
- Open a web browser on your PC.
- Enter the initial IP address of the product (192.168.1.99) in the address bar to connect.
2. **Setting a Password:**
- When accessing the product through the web browser for the first time, you need to register a login password.
- The password should contain 8 or more characters, with a combination of English uppercase/lowercase letters, numbers, or special characters.
- Avoid using the same character repeatedly or consecutive keyboard inputs for enhanced security.
3. **Logging In:**
- Enter "admin" as the user ID.
- Enter the password you set during the password setup.
- Click on the "Login" button to access the product.
4. **Resetting the Product:**
- If you lose the password, press the "RESET" button on the product for about 12 seconds to reset it.
- All previously set values will be reset as well, so ensure you do not lose the password.
5. **Additional Information:**
- Do not disconnect the power until the system initialization is complete after pressing the "RESET" button or during product resetting. It may take up to 10 minutes to reboot after resetting the product.
- For further details and troubleshooting, refer to the product manuals available on the Hanwha Vision website.
By following these steps, you should be able to access and configure your Hanwha Vision SPA-D1000 IP Audio Module successfully on your network.
Add New Comment