User Manual Q&AAnswer
Dec 09, 2025 - 09:22 AM
To access the camera's web interface for live video viewing and configuration modifications, follow these steps:
1. Install and execute the "Device Config Tool" on a computer connected to the same network as the camera.
2. Press the "Search" button within the Device Config Tool. This will search for IP cameras connected to the same router on the network. It may take several seconds to complete, and the default IP address is 192.168.1.168.
3. Once the search is complete, click on the camera IP or manually type the IP address using Internet Explorer.
4. The camera may use Dynamic or Static IP addressing. An example of a typical static IP setting is as follows:
- IP Address: 192.168.0.10 (you can change the last column)
- Netmask: 255.255.255.0
- Gateway: 192.168.0.1
- DNS1/2: You can copy the PC’s network properties. This is for an internet environment.
5. Input "admin" for the user ID and password. If this is the user's first time logging into the camera, they will be prompted to set a new password.
6. If the password is unknown, hold the RESET button located on the camera for about 10 seconds and reload the "Device Config Tool."
7. To access the camera web interface, the user may be prompted to download and install the Active-X web plugin.
8. Once installed, the user will be able to view live camera video and make necessary configurations.
For more detailed instructions and information, you can download the full Web Admin manual from the camera's product page on www.seco-larm.com.
Add New Comment