How can I configure the TxBlock-USB transmitter for temperature measurement using different sensors? (NOVUS TxBlock USB Transmitter temperature User Manual NOVUS TxBlock USB Transmitter temperature User Manual)

Answer

manuals.plus

Dec 08, 2025 - 02:01 PM

To configure the TxBlock-USB transmitter for temperature measurement using different sensors, follow these steps:

1. **Software Installation**: Download and install the SigNow or TxConfig II software from the NOVUS website.

2. **Connection**: Connect the TxBlock-USB transmitter to your computer's USB port using a USB cable. Ensure that the transmitter is not connected to the process and the equipment is not powered.

3. **Configuration Interface**: Launch the SigNow or TxConfig II software. The software will display information about the model, serial number, and firmware version of the transmitter.

4. **Configuration Parameters**: In the software, navigate to the General and Settings screens to configure the following parameters:

- Input Type

- Temperature Unit

- Output Range

- Linearization

- Damping

- Tag

- Filter

5. **Sensor Selection**: Choose the appropriate sensor type from the available options listed in Table 1 of the manual. Ensure that the sensor range selected does not exceed the maximum measurement range defined for the sensor.

6. **Sensor Connections**: Follow the electrical connection guidelines provided in the manual for different sensor types, such as PT100, PT1000, NTC, Thermocouples, and Voltage (0-50 mV).

7. **Offset Correction**: Use the software to adjust the sensor offset if needed. This correction helps in maintaining measurement accuracy, especially when replacing sensors.

8. **Save Configuration**: Apply the new setup by sending it to the transmitter. The configuration changes will be immediately adopted by the TxBlock-USB transmitter.

9. **Operation**: After configuration, you can connect the transmitter to the process for temperature measurement. Ensure that the transmitter accuracy is based on the maximum range of the sensor used.

By following these steps and referring to the detailed instructions provided in the manual, you can effectively configure the TxBlock-USB transmitter for temperature measurement using different sensors.