User Manual Q&AAnswer
Dec 08, 2025 - 01:35 PM
To set up and operate the UNI-T UAP500A Programmable AC Power Source safely and effectively, follow these steps:
1. **Initial Setup:**
- Connect the power cable correctly to the AC power input socket on the rear panel of the power supply.
- Ensure the power supply is connected to a suitable power source (AC 220V±10% V or AC 110V±10% V) with the correct frequency (50/60Hz).
- Check that the input and output terminal fuses are correctly installed (250V/10A).
- Make sure the ground wire of the three-phase socket is properly grounded before use.
2. **Power On:**
- Press the power button on the front panel to activate the instrument. The screen will display "INIT" during the self-test process.
- Once the self-test is complete, the screen will display the current state of the power supply.
3. **Measurement Setup:**
- Use the rotary xxxx or keypad to set the output voltage, protective current, and output frequency according to your requirements.
- Press the appropriate keys (V Set, F Set) to enter the setup mode for voltage and frequency adjustment.
- Follow the on-screen instructions to adjust the parameters as needed.
4. **Output Control:**
- Connect the load to the power output terminal.
- Press the On/Off key to enable the output (green indicator) and adjust the voltage and frequency settings as required.
- Press the On/Off key again to disable the output.
5. **Safety Precautions:**
- Ensure the instrument is used in a suitable operating environment (0-40℃, 20-80%RH) with proper ventilation.
- Do not open the instrument cover or attempt any unauthorized modifications.
- Clean the instrument exterior with a soft damp cloth, ensuring it is unplugged from the power source.
By following these steps and referring to the user manual for detailed instructions, you can set up and operate the UNI-T UAP500A Programmable AC Power Source safely and efficiently.
Add New Comment