User Manual Q&AAnswer
Dec 08, 2025 - 09:37 AM
After removing the printed object from the building stage, follow these steps to clean it properly:
1. Use an ultrasonic cleaner and 95% alcohol for 60 seconds to remove uncured resin from the surface.
2. Ensure that the object has been thoroughly cleaned.
3. Leave the object in a cool, well-ventilated place for at least 30 minutes without exposure to light. Alternatively, you can gently apply compressed air to dry the printed object.
4. For hollowed models, make sure to clean every detail and inner parts thoroughly.
Referencing the Phrozen Resin 1 Aqua Snow Gray 8K user guide, it is recommended to use an ultrasonic cleaner and 95% alcohol for cleaning. Additionally, proper ventilation and drying time are crucial to ensure the printed object is clean and ready for post-curing or further processing.
Add New Comment