User Manual Q&AAnswer
Dec 06, 2025 - 02:29 AM
To access the eGauge device directly without using a router or network connection, follow these steps based on your operating system:
**For Microsoft Windows 10, 8, and 7:**
1. Open the Start menu and navigate to Control Panel > Network and Sharing Center.
2. Disable any network connections not used for connecting to the eGauge.
3. Right-click the adapter you will use to connect to the eGauge and choose Properties.
4. Click on Internet Protocol Version 4 (TCP/IPv4) and then Properties.
5. Select "Use the following IP address" and enter:
- IP address: 192.168.1.11
- Subnet mask: 255.255.255.0
6. Save the changes and access the eGauge at http://192.168.1.88.
**For Mac OS X:**
1. Click the network icon in the upper right corner and choose Open Network Preferences.
2. Turn off Wi-Fi and select Ethernet.
3. Choose "Manually" under Configure IPv4 and enter:
- IP address: 192.168.1.11
- Subnet mask: 255.255.255.0
4. Save changes and access the eGauge at http://192.168.1.88.
**For Linux/Unix:**
1. Open a terminal session.
2. Use the command ifconfig to find your network connections.
3. Enter the following commands:
- sudo ifconfig [eth con] down
- sudo ifconfig [eth con] 192.168.1.11 netmask 255.255.255.0
- sudo ifconfig [eth con] up
4. Access the eGauge at http://192.168.1.88.
By following these steps, you can directly connect to the eGauge device for troubleshooting, configuration, or data retrieval purposes when a network connection is not available.
Add New Comment