User Manual Q&AAnswer
Dec 06, 2025 - 02:03 AM
To adjust the sensor range and output timer on the ENFORCER SD-927PKC-NEQ Wave To Open Sensor with Manual Override Button, follow these steps:
1. **Adjusting the Sensor Range:**
- To increase the sensor's range, turn the trimpot clockwise.
- To decrease the sensor's range, turn the trimpot counterclockwise.
2. **Adjusting the Output Timer:**
- To increase the output duration, turn the trimpot clockwise.
- To decrease the output duration, turn the trimpot counterclockwise.
- To set the output to toggle mode, turn the trimpot to the minimum setting.
3. **Adjusting the LED Color:**
- The default LED color setting is red for standby and green when triggered.
- To reverse the LED color indicator to green for standby and red when triggered, remove the jumper located at the right side of the terminal block.
By following these steps, you can customize the sensor's range, output duration, and LED color to suit your specific requirements. Remember to test the sensor after making adjustments to ensure it functions as intended.
Add New Comment