User Manual Q&AAnswer
Dec 06, 2025 - 12:07 AM
To add a new sensor to the ocBridge Plus receiver, follow these steps:
1. **Registering a Device:**
- Go to the "Configuration" mode in the configuration software.
- Select "Add Device" from the menu.
- Follow the on-screen instructions to register the new sensor. If the sensor was mistakenly registered in the wrong zone, click on its "Properties" button to select a new zone for the sensor.
2. **Adding a Zone:**
- Go to the "Configuration" mode in the configuration software.
- Select "Add Zone" from the menu.
- Enter the name of the new zone and click "Save." The new zone will then appear in the list of zones.
3. **Radio Signal Test:**
- Check the signal level of the connected devices by accessing the radio signal test on the "System's monitor" page of the configuration software.
- Press the button with the antenna against the selected sensor to start the radio signal test. This should be done only when the sensors are in operating mode and there is no red light.
By following these steps, you can successfully add a new sensor to the ocBridge Plus receiver and ensure proper connectivity and functionality within your system.
Add New Comment