User Manual Q&AAnswer
Dec 05, 2025 - 11:53 PM
To change the printing options and adjust temperature and humidity settings on the PPI HumiTherm Plus Recording Plus Printer Interface, follow these steps based on the manual provided:
1. **Printing Options:**
- Press the "Select" button to navigate to the "Prnt Option" parameter.
- Use the navigation buttons to choose between "None," "Print (New)," "Re-Print (Old)," or "Print Info Page."
- The default setting is "None," which means no automatic printing. Adjust as needed.
2. **Temperature and Humidity Settings:**
- Navigate to the "Temp. Set Value" and "%RH Set Value" parameters to set the desired temperature and humidity ranges.
- Adjust the "Low" and "High" limits for both temperature and humidity using the navigation buttons.
- The default values are 25.0 for temperature and 60.0 for humidity.
3. **Deviation Settings:**
- Set the deviation values for temperature and humidity by adjusting the "Lo Deviation" and "Hi Deviation" parameters.
- The default deviation value is 2.0 for both temperature and humidity.
4. **Changing Password:**
- If you need to change the password, navigate to the "Change Password" parameter and enter a new password within the specified range (1 to 100).
5. **Saving Changes and Exiting:**
- After making the desired adjustments, ensure to save the changes by following the instructions provided in the manual.
- Exit the setup mode by confirming the changes and selecting "No" when prompted to exit.
Refer to the manual for detailed instructions and specific button combinations to navigate through the settings and make changes effectively. For further assistance or troubleshooting, you can contact PPI support using the provided contact information.
Add New Comment