User Manual Q&AAnswer
Dec 05, 2025 - 10:04 PM
To change the control setpoint on the PPI FrizCon Deep Freezer Controller with Graphic Display, follow these steps:
1. Access the Operator Parameters menu on the controller by navigating through the settings.
2. Locate the "Ctrl Setpoint" parameter in the menu.
3. Adjust the setting within the range of "Setpoint Low Limit to Setpoint High Limit" as needed. The default value is -80.0.
4. Use the keys on the front panel layout to input the desired control setpoint value.
5. Confirm the changes and save the new control setpoint setting.
Refer to the instruction manual for more detailed instructions and specific steps on navigating the menu and making parameter adjustments on the deep freezer controller.
Add New Comment