User Manual Q&AAnswer
Dec 05, 2025 - 03:23 PM
To adjust the detection area, time delay, and daylight threshold for the Skydance EMR Microwave Sensor RF Switch & Dimmer, you can follow these steps as outlined in the user guide:
1. **Detection Area Adjustment:**
- Rotate the xxxx potentiometer to reduce or increase the detection area to fit the specific application. The detection area can be adjusted to precisely match the requirements of your space.
2. **Time Delay Setting:**
- The time delay refers to the period the light remains on after no motion is detected. You can set the time delay according to your preference by following these steps:
- For typical applications like passage, staircase, balcony, corridor, cloakroom, storeroom, garage, kitchen, dining room, toilet, meeting room, indoor public access, and underground public access, refer to the recommended settings provided in the user manual.
- Adjust the hold time using the xxxx potentiometer to set the desired duration before the light turns off in the absence of motion.
3. **Daylight Sensor Adjustment:**
- The daylight sensor allows you to control when the lamp illuminates based on ambient brightness levels. You can set the sensor to only activate the light when the ambient light falls below a defined threshold. Follow these steps to adjust the daylight sensor:
- Set the daylight sensor to the desired lux level (e.g., twilight, evening, darkness, daytime) using the xxxx potentiometer.
- Note that the daylight sensor is active only when the lamp is completely off, and the lux level refers to the internal light reaching the sensor.
By following these instructions and adjusting the settings as needed, you can customize the operation of the Microwave Sensor RF Switch & Dimmer to suit your specific requirements and preferences.
Add New Comment