User Manual Q&AAnswer
Dec 02, 2025 - 09:30 AM
To switch between Open-Mode and Cartridge mode on your Formlabs printer when using the ApplyLabWork PT-EX001TN resin, follow these steps based on the provided instructions:
**Switching to Open-Mode (Form2 only):**
1. Ensure the printer is idle.
2. Tap the touchscreen and select the "printer" icon to access the menu.
3. Open the "Settings" menu.
4. Select "Open Mode."
5. Set the mode to "On."
**Switching to Cartridge mode (Form2 & Form3):**
1. Refill the corresponding cartridge (e.g., FormLabs Grey version 4 cartridge).
2. Open the air vent on the cartridge and turn it upside down.
3. Allow the cartridge to drip dry through the air vent for 10 minutes to avoid cross-contamination.
4. Refill the cartridge with the PT-EX001TN resin.
5. Shake the cartridge well for 2 minutes to ensure proper mixing.
6. Insert the cartridge into the printer and proceed with printing. Note that the cartridge may work for up to 2 refills before being locked by Formlabs software.
**Additional Notes:**
- Cross-contamination of resins could cause size inaccuracy or wavy lines, so ensure proper handling and cleaning procedures are followed.
- It is recommended to follow the specific instructions for each mode to ensure optimal printing results with the ApplyLabWork PT-EX001TN resin.
Add New Comment