User Manual Q&AAnswer
Dec 01, 2025 - 04:26 AM
To connect two JEGS 86012 Inverter Generators for parallel operation, follow these steps as outlined in the user manual:
1. **Ensure Both Generators Are the Same Model:** Only connect two 86012 Generators for parallel operation. Do not connect generators that are different models.
2. **Use a Parallel Operation Cable Kit:** You will need a parallel operation cable kit designed to work with the 86012 Generator for this setup.
3. **Prepare Both Generators:** Make sure the Economy switch is in the same position on both generators. All electrical devices should be turned off and disconnected from the generators before starting the engines.
4. **Start the Generators:** Start both generator engines. Ensure that the green AC Pilot indicator light comes on for each generator.
5. **Connect Electrical Devices:** When the engines have stabilized, plug in electrical devices to the AC receptacles and turn on the first load. Allow the generator output to stabilize before plugging in the next load.
6. **Monitor Load:** Limit the start-up time to 3 seconds for loads requiring maximum output. For continuous operation, do not exceed the rated output.
7. **Load Management:** Plug in devices with the largest electrical demand output first and the smallest electrical demand last to prevent overloading the generators.
8. **Safety Precautions:** Always use electronic devices that are in good working order and do not exceed the rated power supply of the parallel generators or the desired receptacle.
Remember to follow these steps carefully and refer to the user manual for additional guidance on parallel operation and load management.
Add New Comment