User Manual Q&AAnswer
Nov 29, 2025 - 09:12 AM
To connect multiple hidealite RX HD 24V IP67 Professional LED Strip Lights together, follow these steps:
1. Cut the LED strips to the desired lengths evenly.
2. Remove the protective paper from the back of each LED strip.
3. Pull the shrink tubing over each LED strip.
4. Solder the cables from one LED strip to the soldering tags on the next LED strip.
5. Heat the shrink tubing to form a tight seal around the soldered connection.
6. Seal the short ends with shrink tubing and use flat nose pliers to ensure a very tight seal.
7. Check that all LED strips light up properly.
8. Connect the fittings of each LED strip to the LED transformer in parallel.
By following these steps, you can easily connect multiple hidealite RX HD 24V IP67 Professional LED Strip Lights together to create a longer lighting setup. Remember to always work with the power off and ensure that the installation is done by a qualified electrician for safety and compliance with local regulations.
Add New Comment