User Manual Q&AAnswer
Nov 28, 2025 - 02:04 PM
To charge the Honeywell HC6 Handheld Data Collection Terminal, you can use either a travel charger or a USB data cable. Here's how to charge using both methods according to the user manual:
1. **Charging with a Travel Charger:**
- Plug the small end of the USB cable into the host's TYPE-C connector.
- Plug the large end of the USB cable into the travel charging plug.
- Plug the travel charging plug into an electrical outlet for charging.
2. **Charging with a USB Data Cable:**
- Plug the small end of the USB cable into the TYPE-C port of the host computer.
- Plug the large end into the USB port for charging.
Ensure that the device is connected properly for charging and monitor the system and charging light to determine the battery status during charging. The lights will indicate the battery capacity as follows:
- Green light always on: Battery capacity > 70%
- Green light flashing: Battery capacity between 20% and 70%
- Red light always on: Battery capacity < 20%
- Red light always on during charging: Device is currently charging
- Green light always on when fully charged
Always use the appropriate charging accessories and follow the instructions provided in the user manual to ensure safe and efficient charging of your Honeywell HC6 Handheld Data Collection Terminal.
Add New Comment