User Manual Q&AAnswer
Nov 27, 2025 - 11:18 AM
To access the camera on your local network using the IP-Tool installer, follow these steps as outlined in the user guide:
1. Make sure the camera and your PC are connected to the LAN.
2. Download the IP-Tool installer from and install it on your PC.
3. Open the installed application.
4. Modify the IP address of the camera. The default IP address is 192.168.226.201. Click on the camera information in the application to display the network information on the right side. Adjust the IP address and gateway of the camera to match your local network segment.
5. Input the administrator password to save the modifications. The default admin password is "123456".
6. Double-click the IP address in the IP-Tool application. This will open a web browser to connect to the camera. Internet Explorer may prompt to download Active X control.
7. Enter the default username and password to log in. The default username is "admin" and the default password is "123456".
By following these steps, you should be able to access and configure your VITEK VTC-TNB8RMA4B Motorized IP Bullet Camera on your local network using the IP-Tool installer as per the user guide instructions.
Add New Comment