How do I connect the Logginet UNI/ZB Registration Unit to the sensors and the Loggisoft program? (MIKSTER Registration Unit Owner's Manual)

Answer

manuals.plus

Nov 26, 2025 - 06:42 PM

To connect the Logginet UNI/ZB Registration Unit to the sensors and the Loggisoft program, follow these steps:

1. Connect the Logginet UNI/ZB Registration Unit to the sensors:

- Identify the sensors you want to connect to the registration unit (Logginet-WS, Logginet Standard, Logginet Clip system sensors, or Loggicar-R vehicle registers).

- Ensure that the sensors are compatible with the Logginet UNI/ZB Registration Unit.

- Connect the sensors to the appropriate communication ports on the registration unit. These ports include RJ45 LAN, RS232, RS485 x2, and OneWire.

2. Connect the Logginet UNI/ZB Registration Unit to the LAN or RS458 connection:

- Choose either the LAN or RS458 connection based on your setup requirements.

- Connect the registration unit to the selected connection using the corresponding cable.

3. Plug in the power source (230V AC):

- Ensure that the registration unit is connected to a power source with the specified voltage (230V AC).

- Plug the power cable into the unit and the power outlet.

4. Transmit data to the Loggisoft program:

- Once the sensors are connected and the unit is powered on, the collected data can be transmitted to the Loggisoft program.

- Use the LAN or RS458 connection to transfer the data to the Loggisoft program for further analysis and monitoring.

For more detailed instructions on using the Loggisoft program, refer to its manual provided by the manufacturer.

By following these steps, you can successfully connect the Logginet UNI/ZB Registration Unit to the sensors and the Loggisoft program for efficient data registration and analysis.