User Manual Q&AAnswer
Nov 25, 2025 - 01:20 PM
According to the BEAMZ PRO 152.112 IGNITE 300 Spot LED Moving Head 2 User Manual, here is how you can connect multiple IGNITE 300 units in a DMX chain:
1. If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
2. Connect the output of one unit with the input of the next unit until all units are connected.
3. At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
By following these steps, you can ensure proper communication and synchronization between multiple IGNITE 300 units in a DMX chain for coordinated lighting effects.
Add New Comment