User Manual Q&AAnswer
Nov 20, 2025 - 03:13 PM
To properly install and set up the SUNELL SN-T5H-P Bi Spectrum Network Camera, follow these steps as outlined in the user manual:
1. **Open Package Examination:**
- Open the package and check for any obvious damage to the product.
- Confirm that all components listed in Table 1-1 and 1-2 are included.
2. **Device Installation:**
- Install the black body by confirming the package number, matching the camera and black body labels, and securely attaching the screws and tapes as shown in the manual.
- Install the camera indoors at a height of 2.2 to 2.3 meters in an environment with no wind and a temperature range of 0°C to 35°C (32°F to 95°F).
3. **Configuration:**
- Access the Configuration menu to set temperature measurement parameters, including ambient temperature, thermal mapping, bad point check, thermal calibration, and measure verification.
4. **Thermal Calibration:**
- Enable and draw the black-body frame for calibration. The live video will display the temperature and frame of the black body.
5. **Thermal Mapping:**
- Set three points to map images of the thermal and visual channels, ensuring both channels have the same view angle.
- Adjust the frame position if needed and input values for horizontal and vertical shift.
6. **Precautions:**
- Avoid heavy loads, intense shakes, and soaking to prevent damage during transportation and storage.
- Keep the device away from heat sources, moisture, extreme temperatures, and strong electric radiation.
- Clean the device with a soft dry cloth or neutral cleanser for stubborn dirt.
By following these installation and setup instructions, you can ensure optimal performance and accuracy of the SUNELL SN-T5H-P Bi Spectrum Network Camera in electronic surveillance applications.
Add New Comment