User Manual Q&AAnswer
Nov 20, 2025 - 11:19 AM
To program the FHCRX-1V2 and FHCRX-2V2 Multi-Frequency Receivers to operate in different modes, follow these steps:
1. **Pulse Mode:**
- In Pulse Mode, the relay contact is active while the transmitter button is pressed.
- For Relay-1 Pulse Mode: Remove JP1 jumper or do not bridge the two pins.
- For Relay-2 Pulse Mode: Remove JP2 jumper or do not bridge the two pins.
2. **Hold Mode:**
- In Hold Mode, the relay changes state at each press of the transmitter button (Hold, Release, Hold, etc.).
- For Relay-1 Hold Mode: Bridge the two pins on JP1 jumper.
- For Relay-2 Hold Mode: Bridge the two pins on JP2 jumper.
3. **Timer Mode:**
- In Timer Mode, the relay will remain active for the programmed duration. The timer is adjustable from 0 seconds to 655.34 seconds in .01-second steps.
- Timer Mode is selectable only with the ATA Programmer.
By following these instructions and correctly setting the relay operating modes, you can customize the behavior of the Multi-Frequency Receivers to suit your specific needs for controlling electronic devices such as garage doors and gate openers.
Add New Comment