User Manual Q&AAnswer
Nov 19, 2025 - 08:48 AM
If you are encountering connection problems with your Hunter ICC2 Modular Controller and LANKIT adapter, you can follow these troubleshooting steps based on the installation guide:
1. Check LED Indicators:
- If the first two LEDs on the LANKIT are solid green, the connection attempt was successful. The LANKIT is now connected to both the router and the Centralus server. Proceed to Software Setup.
- If the first light remains solid red after an extended period (up to two minutes), the connection attempt was unsuccessful.
- Cycle power to the LANKIT and retry the connection.
- Double-check that the router is operating properly. Reset the router if necessary.
- If the first light turns green, but the second light is red, the LANKIT was able to connect to the router, but not to the Centralus server.
- Check the internet connection from the router and retry.
2. Verify Connections:
- Ensure all cables are securely connected as per the installation instructions.
- Check that the network cable is properly connected to both the LANKIT and the internet access point.
- Confirm that the power source is connected to the LANKIT adapter.
3. Restart Devices:
- Power off the Hunter ICC2 controller and the LANKIT adapter.
- Restart both devices and allow them to reconnect to the network.
4. Contact Customer Support:
- If the issue persists, refer to the troubleshooting section in the user manual for additional guidance.
- Contact customer support for further assistance with troubleshooting the connection issue.
By following these steps and referring to the user manual, you should be able to troubleshoot and resolve any connection issues with your Hunter ICC2 Modular Controller and LANKIT adapter effectively.
Add New Comment