User Manual Q&AAnswer
Nov 18, 2025 - 03:26 PM
To change the IP address of your Dahua All-in-one Bullet Network Camera, you can follow the steps outlined in the manual:
1. **Search for Devices:**
- Open the ConfigTool.exe tool on your computer.
- Click on "Search Setting."
- Select the searching way: Current Segment Search or Other Segment Search.
- Enter your username and password.
- Click OK.
2. **Initialize Device:**
- Select the uninitialized device(s) you want to change the IP address for.
- Click on "Initialize."
- Set and confirm the password for the device(s).
- Enter a valid email address.
- Click Next.
- Select Easy4ip or Auto-check for updates if needed.
- Click OK to initialize the device.
- Click Finish.
3. **Changing Device IP Address:**
- Search for devices in your network segment using the ConfigTool.
- Select the device(s) whose IP addresses need to be changed.
- Click on "Batch Modify IP."
- Select Static mode and enter the new IP address, subnet mask, and gateway.
- Click OK.
4. **Logging in to Web Page:**
- Open an Internet Explorer browser.
- Enter the new IP address of the camera in the address bar.
- Enter your username and password.
- Click Login.
- Follow any setup wizard instructions if displayed.
By following these steps, you should be able to successfully change the IP address of your Dahua All-in-one Bullet Network Camera. Remember to ensure that the new IP address is within your network's range and that you have the necessary permissions to make these changes.
Add New Comment