User Manual Q&AAnswer
Nov 16, 2025 - 09:52 AM
To install the GROTHE MONTILUX 2154 Push Button, follow these steps:
1. **Opening the Housing:**
- Use a flat screwdriver to remove the nameplate cover.
- Under the nameplate, you will see two slots. Use a suitable screwdriver to pierce these slots and tilt them as shown in the illustration.
2. **Connecting the Push Button:**
- Loosen the xxxx using a screwdriver.
- Insert the stripped wire under the plate and tighten the xxxx securely.
3. **Connecting an LED (Optional):**
- If you wish to connect an LED for illumination, refer to the connection diagram provided in the manual.
4. **Technical Data:**
- Ensure that the installation is carried out in a de-energized state by a qualified electrician.
- The product operates at a maximum of 12V (AC/DC 50mA - 1.5A) and the LED requires 8-12V (AC/DC 0.01A).
- Use wires with a diameter of 0.6 - 0.8mm.
- The operating temperature range is -20°C to 50°C, and the product is rated IP41 for protection against solid objects and water.
- The operating force of the push button is approximately 6N.
5. **Contact Information:**
- For further assistance or inquiries, you can reach out to Grothe GmbH at Löhestraße 22, 53773 Hennef, or contact them via email.
Remember to always prioritize safety during installation and consult a qualified electrician if needed.
Add New Comment