How do I set up the wireless configuration for the ICU Medical Cogent Hemodynamic Monitoring System? (icu medical Hemodynamic Monitoring User Guide)

Answer

manuals.plus

Nov 14, 2025 - 02:44 PM

To set up the wireless configuration for the ICU Medical Cogent Hemodynamic Monitoring System, follow these steps as outlined in the user guide:

1. **Mounting the Display Unit:** The display unit can be mounted to an IV pole, up to 50 feet or 15.24 meters from the base unit.

2. **Charging the Display Unit:** Plug in the display charger cable to the connector on the display unit and an electrical outlet. When the battery icon displays all green bars, the unit can be used wirelessly for up to four hours.

3. **Initializing the System:** Connect the AC power supply cable to the DC connector on the base unit and plug it into an electrical outlet. The base unit will automatically power on. Press the Power button on the top right corner of the display module.

4. **New Patient Setup:** Select the New Patient button and enter the required Patient Information on the screen. Save each entry by selecting the check mark.

5. **Thermodilution CCO Setup:** Connect the Thermal Coil cable and Cardiac Output cable to the front panel of the base unit. Select the check mark button on the Technology Selection screen to accept Thermodilution CO and activate CCO.

6. **PulseCO™ CCO Arterial Setup:** Connect the CardioFlo™ cable to the base unit and the sensor to the catheter lumen. Follow the steps to confirm alignment and zero the pressure waveform.

7. **SvO2/ScvO2 Setup:** Set upper and lower alarm limits, scale limits, and attach the OpMod cable to the optical connector on the base unit for warming up.

8. **Calibration:** Choose between Pre-Insertion Calibration or In-Vivo Calibration methods for the Venous O2 Calibration process.

9. **Powering Off:** To power off the system, select the Main Menu button, then select the Power Off button and confirm by selecting the check mark.

10. **FCC and ISED Compliance:** The device complies with FCC and ISED regulations for wireless operation. Ensure proper placement of the Patient Interface Module (PIM) or base unit when monitoring in wireless configuration.

By following these steps, you can successfully set up and use the wireless configuration of the ICU Medical Cogent Hemodynamic Monitoring System.