User Manual Q&AAnswer
Nov 13, 2025 - 01:30 PM
To ensure that your Valve Controller 2 and Bulldog Valve Robot Kit is properly installed and functioning correctly, follow these steps:
1. **Physical Installation Check:**
- Verify that the Valve Controller 2 is securely attached to a stable surface using the provided brackets and screws.
- Ensure that the Valve Control Cable and Valve Status Cable are properly connected and secure between the Valve Controller 2 and the Bulldog Valve Robot.
- Confirm that the Bulldog Valve Robot is securely attached to the ball valve using the appropriate bracket and screws.
- Check that all cables are connected as per the installation instructions.
2. **Power Up and Connection Check:**
- Turn on the Valve Controller 2 by pressing the SET button until the LED blinks (red, then green).
- Verify in the YoLink app that the Valve Controller 2 is indicated as online.
- Connect the Valve Controller's cables to the Bulldog Valve Robot as instructed.
- If using the power adapter, connect the 12VDC input cable to the power adapter cable and plug it into a power source.
3. **Functionality Testing:**
- Test the Valve Controller 2 and Bulldog Valve Robot by pressing the SET button on the controller and observing the opening and closing action of the Bulldog and the ball valve. Ensure the valve opens and closes completely without any water flow when closed.
- Listen for the sound of the motor operating and ensure it is even without any strain or increased noise.
- Test the operation of the Valve Controller 2 from the YoLink app by opening and closing the valve using the app.
4. **Additional Troubleshooting:**
- If you encounter any issues during testing, refer to the full installation and user guide for troubleshooting steps.
- Contact YoLink support if you experience any problems or have questions that are not addressed in the manual.
By following these steps and testing the functionality of your Valve Controller 2 and Bulldog Valve Robot Kit, you can ensure that the devices are properly installed and working as intended for remote water supply control.
Add New Comment