User Manual Q&AAnswer
Nov 04, 2025 - 02:52 PM
To replace the sensor in your Novus RHT-WM Transmitter, follow these steps as outlined in the instruction manual:
1. **Disconnect the device from the power source:** Before starting the replacement process, ensure that the transmitter is not connected to any power source to avoid any electrical hazards.
2. **Remove the sensor cover:** Locate the sensor cover on the device and carefully remove it to access the sensor inside.
3. **Remove the sensor from the device:** Once the sensor cover is removed, gently detach the existing sensor from the device by following the manufacturer's instructions.
4. **Install the new sensor in the device:** Take the new sensor and securely install it in the designated location within the transmitter, ensuring it is properly aligned and connected.
5. **Replace the sensor cover:** After the new sensor is in place, reattach the sensor cover to protect the sensor and ensure it is securely fastened.
6. **Reconnect the device to the power source:** Once the sensor replacement is complete, you can reconnect the Novus RHT-WM Transmitter to the power source and ensure it is functioning correctly.
During the sensor replacement process, it is important to handle the sensors with care to avoid any damage. Avoid touching the sensor's active part and use clean antistatic gloves to prevent static discharges. Additionally, follow the recommended steps for sensor calibration restoration if needed, as outlined in the manual.
By following these steps and precautions, you can safely and effectively replace the sensor in your Novus RHT-WM Transmitter to maintain accurate measurements and device functionality.
Add New Comment