How do I properly install and connect the device to ensure safe and efficient operation? (veratron GNSS Receiver Instruction Manual)

Answer

manuals.plus

Nov 02, 2025 - 10:21 AM

To properly install and connect the Veratron GO GPS GNSS Receiver, follow these steps as outlined in the instruction manual:

1. Before assembly, ensure safety precautions are taken to avoid short circuits, cable burning, and battery explosion. Remove the ignition key and detach the battery negative pole terminal.

2. Avoid NMEA 2000 network overload and burnt cables by checking the current absorption on devices connected to the NMEA 2000 network. Dimension the power cable accordingly to prevent issues.

3. Check the box contents to ensure you have the Veratron GO GPS Receiver and the installation instructions.

4. Review the technical specifications provided in the manual, including the material, connector type, IP protection class, supply voltage, time to first fix (TTFF), position accuracy, GNSS augmentation, reception channels, update rate, and NMEA 2000 data details.

5. Identify the Micro-C 5-pin M12 connector on the product side and understand its pin configuration for proper connection.

6. Install the Veratron GO GPS Receiver in a suitable location following the guidelines provided in the manual. The address and contact information for Veratron are also provided for any inquiries or support needed.

7. For more information on available accessories, refer to the accessory catalog or visit the Veratron website.

By following these installation instructions and guidelines, you can ensure the proper installation and connection of the Veratron GO GPS GNSS Receiver for safe and efficient operation.