User Manual Q&AAnswer
Oct 31, 2025 - 04:51 PM
To program the SmartFusion device using the SmartFusion Development Kit, follow these steps:
1. **Ensure Correct Jumper and Switch Settings:**
- Confirm that the jumpers and switches on the development board are set correctly. For programming the SmartFusion device, SW9 must be off (JTAGSEL = H). Refer to the user guide for the factory default settings and the location of all jumpers.
2. **Connect the Board:**
- Connect one of the USB cables from your PC to the USB connector on the development board.
- Connect the Low-cost programming stick (LCPS) to your PC via a USB cable.
- Connect the LCPS to the programming header on the board.
- Connect the 5 V power supply to the board.
3. **Software and Licensing:**
- The SmartFusion Development Kit is supported by Libero® System-on-Chip (SoC) v10.0 or later. Install the necessary software tools such as SoftConsole Software IDE and FlashPro for software design and debug.
- Additional software support is available from Keil and IAR Systems, which can be installed separately. Refer to the user guide for more information on software compatibility.
- Ensure you have a valid Gold, Platinum, or Standalone Libero license for using the software tools. You can request a new license from your Microsemi Customer Portal account if needed.
4. **Running the Manufacturing Test:**
- To verify the device and board connections, you can run the manufacturing test using the provided test files. Instructions for running the test are available in the SmartFusion Development Kit User’s Guide.
5. **Technical Support:**
- If you encounter any issues during the programming process or have further questions, you can access technical support online or contact Microsemi via email.
- For local sales offices, representatives, or distributors, visit www.microsemi.com/soc/company/contact to find the nearest contact for assistance.
By following these steps and referring to the SmartFusion Development Kit User’s Guide for detailed instructions, you can successfully program the SmartFusion device using the provided kit components.
Add New Comment