User Manual Q&AAnswer
Oct 31, 2025 - 04:49 PM
To connect the SmartFusion2 Development Kit board to your PC for programming and power, follow these steps:
1. Connect the USB mini-B cable from your PC to the USB Mini-B connector (FTDI) interface on the board.
2. Connect the FlashPro4 programmer to your PC via the USB mini-B cable.
3. Connect the FlashPro4 programmer to the board via the FP4 header.
4. Connect the 12 V DC power supply to a wall outlet and to the board via the DC jack.
5. Switch the power on to the board via the power-on switch (SW7).
By following these steps, you will have successfully connected the SmartFusion2 Development Kit board to your PC for programming and power.
Add New Comment