User Manual Q&AAnswer
Oct 31, 2025 - 03:05 PM
To program the SmartFusion2 SoC FPGA Advanced Development Kit using the on-board programmer, follow these steps:
1. Connect the development board to your computer using the USB A male to micro-B male cable provided in the kit.
2. Power on the board using the 12 V, 5 A AC power adapter.
3. The kit implements an on-board programmer, eliminating the need for a standalone FlashPro hardware. You will need to use the FlashPro5 programming procedure to program the device using the on-board programmer.
4. Refer to the SmartFusion2 SoC FPGA Advanced Development Kit User Guide for detailed programming procedures. You can access the user guide at www.microsemi.com/document-portal/doc...
5. Follow the programming instructions provided in the user guide to successfully program the SmartFusion2 SoC FPGA using the on-board programmer.
If you encounter any issues during the programming process, you can reach out to Microsemi's technical support online or via email for assistance.
Add New Comment