User Manual Q&AAnswer
Oct 31, 2025 - 02:37 PM
To perform a continuity test using the KAIWEETS ST100 Smart Pen-type Multimeter, follow these steps:
1. **Power on the meter:** Press and hold the power button for about 2 seconds to turn on the multimeter.
2. **Select the continuity function:** Press the "FUNC" key to select the continuity function. The continuity function is used to check if a circuit is complete (has continuity) or if there is a break in the circuit.
3. **Prepare the probes:** Insert the black probe into the "COM" jack on the multimeter.
4. **Test for continuity:**
- Touch the probe tips to both ends of the circuit or component you want to test for continuity.
- If there is continuity (the circuit is complete), the multimeter will emit a beep sound, and the display may show a low resistance value.
- If there is no continuity (the circuit is open), there will be no beep sound, and the display may show a high resistance value or "OL" (open loop).
5. **Interpreting the results:**
- A beep sound and a low resistance value indicate continuity in the circuit.
- No beep sound and a high resistance value or "OL" indicate an open circuit with no continuity.
6. **Finish the test:** After completing the continuity test, turn off the multimeter to preserve battery life.
Remember to always follow safety precautions and the guidelines provided in the user manual when using the KAIWEETS ST100 Smart Pen-type Multimeter for any measurements.
Add New Comment