User Manual Q&AAnswer
Oct 31, 2025 - 11:21 AM
To install and set up the Titan Controls Tali 3-in-1 VPD Sensor for optimal performance in your growing environment, follow these key steps as outlined in the manual:
1. **Check Sensor Condition:** Before installation, ensure that the HGC702000-VPD sensor is in good condition.
2. **Read Manual:** Carefully read the HGC702000-VPD manual before installation to understand the sensor's functions and features.
3. **Understand VPD Calculation:** The sensor calculates Vapor Pressure Deficit (VPD) based on temperature, humidity, and air pressure readings to help optimize plant growth.
4. **Transpiration Management:** Maintain appropriate transpiration levels to ensure optimal water absorption and plant health.
5. **Avoid Interference:** Do not install the sensor near maritime safety communications equipment or critical navigation devices operating between 0.45-30 MHz to prevent interference.
6. **Proper Installation:** Follow recommended installation methods to position the sensor correctly for accurate readings.
7. **Connection to Controller:** Connect the sensor cable to the controller (EL3) as instructed in the manual.
8. **Sensor Configuration:** After connecting the sensor to EL3, locate the sensor on the "Sensor List" screen and adjust settings as needed.
9. **Zone Selection:** Default sensors to "Zone A" grouping and switch between "Zone A" and "Zone B" as required.
10. **Default Sensor:** Select a sensor as the default for the home screen display.
11. **Ventilated Environment:** Ensure the sensor is used in a ventilated environment for accurate readings.
12. **Positioning:** Install the sensor in the recommended position to avoid non-optimal readings.
By following these steps, you can effectively install and set up the Titan Controls Tali 3-in-1 VPD Sensor to monitor and optimize the growing conditions for your plants. If you encounter any issues or have further questions, refer to the manual or contact Titan Controls for technical support.
Add New Comment