User Manual Q&AAnswer
Oct 29, 2025 - 04:48 PM
If your LED Pool-Wall Light is not lighting up, you can follow these troubleshooting steps as outlined in the owner's manual:
1. **Check Power Cord**: Ensure that the power cord is securely plugged into the electrical outlet. Tighten the intermediate connection between the transmitter and the transformer.
2. **Check GFCI**: Verify if the Ground Fault Circuit Interrupter (GFCI) is tripped. If it is, contact the Intex Service Center for assistance.
3. **Orientation and Alignment**: Make sure the pool light and the transmitter are correctly oriented and aligned. Rearrange their positions if needed as per the setup instructions provided in the manual.
4. **Water Inside Pool Light Unit**: If there is water inside the pool light unit, contact the Intex Service Center for further assistance.
5. **Possible Transmitter or Transformer Failure**: If none of the above steps resolve the issue, there might be a problem with the transmitter or transformer. In this case, it is recommended to contact the Intex Service Center for professional help.
If you continue to experience difficulty with your LED Pool-Wall Light, please refer to the troubleshooting guide in the manual or contact the Consumer Service Department for further assistance.
Add New Comment