User Manual Q&AAnswer
Oct 29, 2025 - 04:05 PM
To program the sensor ID into the receiver for the Doran 3604AG Tire Pressure Monitoring System, follow these steps as outlined in the user manual:
1. Press the P button on the receiver to enter the program mode.
2. Select the wheel position using the navigation keys and press the S button to enter the sensor ID programming mode.
3. Input the last three digits of the sensor ID into the receiver by navigating the arrow keys.
4. Press and hold the S button for three seconds to confirm the entered sensor ID information.
5. If there are more wheels to be programmed, repeat steps 2-4 for each additional sensor.
6. Finish the programming process by pressing and holding the P button for 5 seconds to exit the program mode.
By following these steps, you can ensure that each sensor ID is correctly programmed into the receiver for accurate tire pressure monitoring with your Doran 3604AG Tire Pressure Monitoring System.
Add New Comment