User Manual Q&AAnswer
Oct 29, 2025 - 03:07 PM
If your Intelligent IFSGA003AC-ANON Dryflow Tri-Tap Water Sensor Tap is not functioning as expected, you can refer to the troubleshooting guide provided in the instruction manual. Here are some common issues and their solutions based on the manual:
1. **No water out:**
- **Possible Causes:** Exhausted battery, water supply cut off, dirt in the filter, low water pressure.
- **Solutions:** Change the battery, check water supply, clean the filter, raise the water pressure.
2. **Water will not turn off:**
- **Possible Cause:** Dirt on the sensor window.
- **Solution:** Clean the sensor window.
3. **Too little water flow:**
- **Possible Causes:** Water supply turned down, dirty filter, low water pressure.
- **Solutions:** Adjust water supply, clean the filter, raise water pressure.
4. **Too much water flow:**
- **Possible Cause:** High water pressure.
- **Solution:** Adjust the water pressure.
5. **Short cycles of battery:**
- **Possible Causes:** Incorrect batteries.
- **Solution:** Change to 4AA Alkaline batteries.
6. **The indicator light is not on:**
- **Possible Causes:** Broken light, wet circuit board or signal line, exhausted battery, poor battery connection.
- **Solutions:** Change the light or circuit board, dry out the wet components, change the battery, check battery connections.
7. **Flashing sensor light:**
- **Possible Cause:** Battery running low.
- **Solution:** Replace the battery.
8. **Inlet filter cleaning:**
- **Possible Cause:** Control box inlet filter clogged.
- **Solution:** Remove the filter and wash out any obstructions.
If you encounter any issues beyond what is listed here, it is recommended to consult a qualified plumber or electrician for further assistance. Remember to follow the aftercare instructions provided to maintain the product's surface properly and ensure its longevity.
Add New Comment