User Manual Q&AAnswer
Oct 29, 2025 - 09:17 AM
To properly configure and mount the Seagate ST4000DM000 Desktop HDD, follow these steps based on the manual:
1. **Handling and Static-Discharge Precautions:**
- Before handling the drive, wear a grounded wrist strap or frequently ground yourself by touching the metal chassis of a computer plugged into a grounded outlet.
- Handle the drive by its edges or frame only.
- Do not touch the connector pins or the printed circuit board.
- Do not remove factory-installed labels from the drive.
2. **Configuring the Drive:**
- SATA drives do not require jumper settings for operation.
- If the drive is not detected, ensure that the SATA-equipped motherboard supports SATA speed auto-negotiation.
3. **SATA Cables and Connectors:**
- Use a SATA interface cable with four conductors in two differential pairs and three ground connections.
- Ensure correct orientation of the SATA connectors when attaching them to the drive and host.
4. **Drive Mounting:**
- Mount the drive in any orientation using four screws in the side-mounting holes or bottom-mounting holes.
- Allow a minimum clearance of 0.030 inches around the drive for cooling.
- Use only 6-32 UNC mounting screws and do not overtighten them.
5. **SATA Interface:**
- The drive uses the industry-standard Serial ATA (SATA) interface supporting various ATA commands.
- Refer to the manual for detailed information on supported ATA commands.
By following these steps, users can properly configure and mount the Seagate ST4000DM000 Desktop HDD for installation in their computer system.
Add New Comment