User Manual Q&AAnswer
Oct 21, 2025 - 04:27 PM
To install the Suitcase Mount DVRS for the Futurecom Mobexcom P25 DVR system, follow these steps as outlined in the user manual:
1. **Open the Suitcase Mount DVRS cover:** Note the location of the mounting screws for the MSU speaker bracket and microphone clip.
2. **Install the microphone clip and speaker bracket:** Connect the speaker connector to the CH harness.
3. **Install the MSU:** Use the supplied MSU thumb screws for installation.
4. **Connect the cables:** Connect the MSU DC power cable, antenna cables, control head cable, and DVR to Mobile cable. Ensure the RF cable marked as “In-Band B” is connected to the in-band antenna port of the Mobile Radio.
5. **Install the speaker, microphone, and Control Head:** Connect the CH DC cable, the other end of the MSU-to-CH cable, and microphone cable.
6. **Program the MSU, DVR, and Portables:** Ensure the templates are fully matched by following the guidelines provided in the DVRS Programming Guide. Connect a PC with compatible Tweaker Programming Software to the DVR USB port located under the cap behind the MSU Speaker at the back end of the suitcase.
Remember to check the tuning of the DVRS Duplexer to ensure frequencies match the DVRS Filtering frequencies. Antennas are not included in the Suitcase Mount package and need to be provided separately. Refer to the manual for a list of approved antennas and associated output powers for the DVRS system.
Add New Comment