User Manual Q&AAnswer
Oct 21, 2025 - 04:05 PM
To verify that the CO2 is going into the tube when using the pdw Fatty Object CO2 Inflator, follow these steps:
1. **Close control xxxx :** Ensure the control xxxx on the inflator is closed before attaching it to the valve.
2. **Thread CO2 cartridge onto inflater:** xxxx the CO2 cartridge onto the inflator until it punctures the cartridge.
3. **Prepare Presta Valve (if applicable):** If using a Presta Valve, open it and tap the valve to release a burst of air and unstick the valve.
4. **Attach nozzle to valve:** Push the nozzle of the inflator onto the valve of the tube.
5. **Release a small amount of CO2:** Open the control xxxx slightly to release a small amount of CO2 into the tube. Verify that the CO2 is entering the tube before proceeding to fill it completely.
6. **Fill the tube:** Once you have confirmed that the CO2 is going into the tube, continue to fill the tube completely by releasing more CO2 as needed.
7. **Finish inflating:** When you have reached the desired pressure, twist the control xxxx to close the flow of CO2 and then pull the nozzle from the tire valve.
By following these steps and verifying that the CO2 is entering the tube during inflation, you can ensure that you are using the pdw Fatty Object CO2 Inflator correctly and effectively inflating your tube.
Add New Comment