User Manual Q&AAnswer
Oct 19, 2025 - 11:25 AM
To reset the ENTTEC STORM10 to factory defaults, you can follow these steps as outlined in the user manual:
1. **Resetting via Web Interface:**
- Access the web interface of the ENTTEC STORM10 using a web browser.
- Navigate to the "Settings" tab within the web interface.
- Look for the "Factory Default" option within the settings.
- Press the "Factory Default" command to initiate the reset process.
- A pop-up confirmation may appear, confirming your decision to reset the device.
- Follow any additional on-screen instructions to complete the factory reset.
2. **Resetting by Reset Button:**
- Power off the ENTTEC STORM10 device.
- Locate the reset button on the device.
- Press and hold the reset button.
- While holding the reset button, power up the device and continue holding the button for 3 seconds.
- Release the reset button once the status LED starts blinking red.
- Power cycle the device to complete the reset process.
3. **Additional Notes:**
- After the factory reset, the ENTTEC STORM10 will revert to the default settings specified in the manual, including network configurations and port settings.
- Ensure that the device is powered off before attempting the reset procedure.
- Follow any specific instructions provided in the manual for resetting the device to factory defaults.
By following these steps, you should be able to successfully reset your ENTTEC STORM10 Ethernet-DMX Converter to its factory settings.
Add New Comment