How do I adjust the position of the roller hardware if I need to trim the rail for my specific application? (FURNITURE FSDH-STRAPKIT-5 Sliding Barn Door Hardware Kit Instruction Manual)

Answer

manuals.plus

Oct 18, 2025 - 09:16 PM

According to the installation manual for the FURNITURE FSDH-STRAPKIT-5 Sliding Barn Door Hardware Kit, if you need to trim the rail for your specific application, it is important to note that trimming the rail will alter the position of the roller hardware. To adjust the position of the roller hardware after trimming the rail, follow these steps:

1. **Trimming the Rail:** If you need to trim the rail to fit your door opening, use a band saw with blades suitable for iron or stainless steel. Trim the rail equally on both sides, up to 2½" on each side. Ensure that the rail is cut evenly on both ends.

2. **Adjusting Roller Hardware:** After trimming the rail, adjust the position of the roller hardware accordingly. The manual suggests that the roller strap [A] should be mounted 5" from the edge of the door to the neck of the roller strap.

3. **End Caps:** Once you have cut the rail to the desired length, add the end caps [D] to the ends of the rail and secure them with a set xxxx . This will provide a finished look and secure the rail.

4. **Final Adjustments:** Make sure to double-check the alignment and positioning of the roller hardware after trimming the rail. Ensure that the roller straps are securely attached to the doors at the correct distance from the edge.

By following these steps, you can successfully adjust the position of the roller hardware after trimming the rail to fit your specific application. Remember to make precise measurements and adjustments to ensure proper functionality of the sliding barn door hardware kit.