User Manual Q&AAnswer
Oct 17, 2025 - 12:15 PM
According to the manual, the address of each module is set using the MIX-4090 programmer tool. Here is the step-by-step process for setting the address:
1. Obtain the MIX-4090 programmer tool.
2. Connect the programmer tool to the MIX-4045 Dual Relay Module.
3. Follow the instructions provided with the programmer tool to input the desired address for the module.
4. Once the address is set, disconnect the programmer tool from the module.
5. Verify that the address has been successfully set by checking the module's LED indicator.
By following these steps, you can ensure that the MIX-4045 Dual Relay Module is correctly addressed and ready to operate with your fire system control panel.
Add New Comment