User Manual Q&AAnswer
Oct 16, 2025 - 04:31 PM
To set the address on the Mircom MIX-M502MAP Interface Module, follow these steps:
1. **General Description:** The MIX-M502MAP Interface Module is designed for intelligent, two-wire systems where the individual address of each module is selected using the built-in rotary decade switches.
2. **Mounting:** The module mounts directly to 4˝ square electrical boxes with a minimum depth of 21⁄8˝. Surface-mounted electrical boxes (SMB500) are available from System Sensor.
3. **Wiring:** Ensure all wiring conforms to local codes and regulations. The module is intended for power-limited wiring only. Install the module wiring according to job drawings and wiring diagrams.
4. **Setting the Address:**
- Refer to the job drawings to determine the specific address required for the module.
- Locate the built-in rotary decade switches on the module.
- Use a small tool, such as a screwdriver, to set the switches to the desired address as specified in the job drawings.
- Ensure the address set on the module matches the address configured in the control panel for proper communication.
By following these steps, you can successfully set the address on the Mircom MIX-M502MAP Interface Module to enable effective communication with the control panel and monitoring of two-wire conventional smoke detectors.
Add New Comment