User Manual Q&AAnswer
Oct 16, 2025 - 02:35 PM
To properly install the Mircom WR-3001W Wireless Input-Output Unit, follow these steps as per the provided manual:
1. **Tools Needed:** Gather the necessary tools including a hexnut driver, precision or jeweler's screwdriver set, Philips screwdriver, wire cutter, and wire stripper.
2. **Precautions:** Before installation, ensure that AC and battery power are disconnected to prevent damage to static-sensitive components. Ground yourself with a proper wrist strap to remove any static charges from your body before handling any boards. Keep Power-Limited and other wiring at least 1/4 inches apart to prevent interference.
3. **Mounting Options:** The unit can be mounted on the wall or ceiling using compatible device boxes such as single gang, double gang, utility boxes, standard 4” by 4” boxes, or standard 4” octagon boxes.
4. **Installation Tips:**
- Perform a visual inspection of parts for any issues.
- Group incoming wires through the top of the enclosure for easy identification and neatness.
5. **Mounting Process:**
- Wire the mounting plate to the standard 120 VAC or 240 VAC service with three wires.
- Snap the Wireless Input/Output unit onto the mounting plate and secure it with a xxxx .
6. **DIP Switch Configuration:** Configure each unit with a PAN ID and channel ID. Set the channel ID and PAN ID to match the Zone Controller for the floor or zone. All devices in the same zone should have the same channel ID and PAN ID. Refer to the LT-6210 Fire-Link 3 Manual for DIP switch settings.
7. **Notification Appliance Wiring:** Follow the instructions in the LT-6210 Fire-Link 3 Manual for wiring the notification appliance to the unit.
By following these steps and guidelines from the manual, you can ensure a proper installation of the Mircom WR-3001W Wireless Input-Output Unit for effective operation.
Add New Comment