User Manual Q&AAnswer
Oct 15, 2025 - 03:42 PM
1. **Registration & Binding:**
- To register the receiver, ensure your radio is in ACCESS mode, power on the receiver while holding the button until the LEDs indicate registration mode. Follow the on-screen prompts to complete registration.
- For binding, select the receiver on your radio, power on the receiver, and press the bind button. Once bound successfully, the green LED will remain lit.
2. **Gyroscope Sensor Calibration:**
- Enable the stabilization function, navigate to the SxR Calibration tool, and follow the on-screen instructions to calibrate the gyroscope sensor on all six surfaces of the receiver.
3. **Flight Modes Setup:**
- The receiver supports Stabilization, Auto Level, Hover, and Knife-Edge flight modes. These modes can be configured using channels CH10 and CH12 with different switch positions. Refer to the manual for detailed switch configurations.
4. **Range Check:**
- Before each flight, perform a range check by placing the model at least 60 cm above non-metallic ground, enter the RF System menu on your radio, select RANGE mode, and ensure the RSSI at 150m is around 45-50.
5. **Failsafe Setting:**
- The receiver offers No Pulses, Hold, and Custom failsafe modes. Configure failsafe settings based on your preference to ensure safe operation in case of signal loss. Remember to set failsafe for each channel if needed.
By following these steps and referring to the detailed instructions in the manual, you can effectively set up and utilize the features of the FrSKY SR10 ARCHER PLUS Receiver for your model.
Add New Comment