User Manual Q&AAnswer
Oct 09, 2025 - 03:48 PM
To properly assemble and install the hyco Flow Through Valve Kit for Speedflow, follow these steps:
1. Assemble the vessel, t-piece, and flow through valve as shown in figure 1 of the installation instructions.
2. xxxx the flow through valve as far into the t-piece as it will go and then turn back if necessary to achieve the orientation shown.
3. Use PTFE tape or a similar sealing material to seal the threads of both the vessel and the flow through valve.
4. Ensure the orientation is correct by positioning the flow through valve water diverter paddle at a 90° angle to the tube as shown in figure 2.
By following these steps and ensuring the correct orientation, you can properly assemble and install the hyco Flow Through Valve Kit for Speedflow for effective usage and performance.
Add New Comment