User Manual Q&AAnswer
Oct 08, 2025 - 12:20 PM
To wire the FX-16EYT-TB Connector for transistor output blocks, follow these steps based on the provided manual:
1. **Terminal Block Wiring:** Ensure that you do not perform external wiring to unused terminals as it may damage the unit. Avoid laying I/O cables next to power cables or sharing the same trunking duct to prevent interference.
2. **Terminal Wiring:** Use crimp-style terminals of the specified dimensions and tighten them at a torque of 0.5 to 0.8 N·m. Incorrect tightening may lead to equipment failures or malfunctions.
3. **Direct Output Blocks Wiring:** For transistor output blocks, the FX-16EYT-TB (sink) model requires a fuse of 2 A for every four points to prevent breakdown of circuits caused by load short-circuit.
4. **On Voltage:** The ON voltage of an output transistor is approximately 1.5 V. When driving a semiconductor device, ensure to pay attention to the input voltage characteristics of the used device.
By following these guidelines and specifications provided in the manual, you can correctly wire the FX-16EYT-TB Connector for transistor output blocks. Always refer to the manual for detailed instructions and safety precautions.
Add New Comment