User Manual Q&AAnswer
Oct 08, 2025 - 10:59 AM
To connect and control multiple AFX LIGHT CLUB-MIX2 LED Par Can units using DMX, follow these steps as outlined in the user manual:
1. **Signal Cable Connection:**
- Use a 3-pin XLR cable to connect the output socket of the master unit to the input socket of the slave unit.
- Connect the DIGITAL OUT socket of the master unit to the IN socket of the slave unit.
- Continue this connection pattern for all units in the chain, connecting the OUT socket of one unit to the IN socket of the next unit.
- Ensure that the diameter of the core of every cable used is at least 0.5mm. Use double core shelter cable if necessary.
- It is recommended to use a DMX signal terminator on the last unit of the chain. The terminator is a XLR connector with a 120Ω resistor between pin 2 and pin 3.
2. **Control Panel Settings:**
- Use the Menu button to select the DMX function.
- Set the DMX mode to either 18CH or 10CH based on your setup.
- Use the ADDR function to set the DMX address for each unit in the chain to ensure they respond to the correct control signals.
3. **DMX Channel Chart:**
- Refer to the last page of the user manual for a detailed DMX channel chart that specifies the control parameters for each channel.
By following these steps, you can successfully connect and control multiple AFX LIGHT CLUB-MIX2 LED Par Can units using DMX for synchronized lighting effects.
Add New Comment