User Manual Q&AAnswer
Oct 08, 2025 - 09:18 AM
According to the Cell2 SW830 Control Panel and Power Module Instruction Manual, here is how you can program the buttons:
1. **ON/OFF or Momentary Button Setting:**
- Press and hold B1 and B4 for 3 seconds to enter PROGRAMMING MODE.
- While in PROGRAMMING MODE, turn ON or OFF the desired button for the following scenario:
- Button B1~B7 Red Backlit
- OFF: ON/OFF (default)
- ON: Momentary
- Once set, press and hold B1 and B4 for 3 seconds to exit PROGRAMMING MODE.
2. **European Siren Interlock:**
- Button B5 and B6 may be configured so that Button B5 turns Button B6 OFF when deactivated and turns itself ON when Button B6 is activated.
- Follow the steps outlined in the manual to set this configuration.
3. **Button Mapping:**
- Button B7 may be set to activate and deactivate by Button B5.
- Follow the instructions in the manual to configure this button mapping mode.
4. **LED Signal Display Mode Change:**
- The 10-LED Signal Display may display either the Lightbar flash signal or the directional/warning advisor flash signal. You can change the display mode by following the steps provided in the manual.
By following the programming instructions in the manual, you can customize the functionality of the buttons on the Cell2 SW830 Control Panel and Power Module to suit your specific needs and preferences.
Add New Comment